ĭensity of crude oil, Density of fuel oils, Density of lubricating oil and Density of jet fuel as function of temperature.Īs shown in the figures, the change in density is not linear with temperature - this means that the volumetric expansion coefficient for water is not constant over the temperature range. įor other substances, see density and specific weight of acetone, air, ammonia, argon, benzene, butane, carbon dioxide, carbon monoxide, ethane, ethanol, ethylene, helium, hydrogen, methane, methanol, nitrogen, oxygen, pentane, propane and toluene. See also other properties of Water at varying temperature and pressure : Boiling points at high pressure, Boiling points at vacuum pressure, Dynamic and kinematic viscosity, Enthalpy and entropy, Heat of vaporization, Ionization Constant, pK w, of normal and heavy water, Melting points at high pressure, Prandtl number, Properties at Gas-Liquid Equilibrium Conditions, Saturation pressure, Specific gravity, Specific heat (heat capacity), Specific volume, Thermal conductivity, Thermal diffusivity and Vapour pressure at gas-liquid equilibrium. See Water and Heavy Water for thermodynamic properties at standard condtions. The density of water depends on temperature and pressure as shown below: The unit for measuring density is gm/cm3 or kg/m3. A higher value of the density indicates smaller the distance among the molecules. The density of any material indicates how tightly the molecules of the material adhere to each other.

Note! Temperature must be within the ranges 0-370 ☌, 32-700 ☏, 273-645 K and 492-1160 °R to get valid values. The density of the material is defined as the weight of the material per unit volume of it. The output density is given as g/cm 3, kg/m 3, lb/ft 3, lb/gal(US liq) and sl/ft 3. The calculator below can be used to calculate the liquid water density at given temperatures. The density of water in kg/m³ is 1000 times greater than the density of water in g/cm³ and circa 16.018 times smaller than the density of water in lb/ft³. See more about the difference between mass and weight Online Water density Calculator The density of water is 1.940 sl/ft 3at 39 ☏ (4 ☌), and the specific weight in Imperial units is

In the Imperial system the mass unit is the slug, and is derived from the pound-force by defining it as the mass that will accelerate at 1 foot per square second when a 1 pound-force acts upon it :ġ = 1 * 1 and 1 = 1 /1 In the SI system, specific weight of water at 4☌ will be: G = acceleration due to gravity, units typically and value on Earth usually given as 9.80665 m/s 2or 32.17405 ft/s 2 For example, the density of water is 1 gram per cubic centimetre, and Earth ’s density is 5.51 grams per cubic centimetre. Density can also be expressed as kilograms per cubic metre (in. For example, the density of water is 1 gram per cubic centimetre, and Earth ’s density is 5.51 grams per cubic centimetre. Density is commonly expressed in units of grams per cubic centimetre. Specific weight is the ratio of the weight to the volume of a substance: The formula for density is d M / V, where d is density, M is mass, and V is volume. Pure water has its highest density 1000 kg/m 3 or 1.940 slug/ft 3 at temperature 4☌ (=39.2☏). Density is the ratio of the mass to the volume of a substance:

Density water